Interior and fittings of Victorian gentleman’s racing cutter Integrity

 

  

  

These photos of the recently launched Victorian gentleman’s racing cutter Integrity designed and built by Stirling & Son of Tavistock in Cornwall are an illustration of how much research and thought has gone into this boat.

As usual, click on the thumbnails for a better view!

Here’s what Will Stirling has to say:

‘The detail of the interior has been taken from photographs of Victorian yachts. The frames of the panelled oak bulkheads are mortice and tenoned together. Loose panels are fitted in a rebate in the frame. The lower panels are fielded, while the upper panels are flat, and a beading or trim is fitted around the edge of each panel to give the bulkhead a three-dimensional feel.

‘The oak has been treated with Van Dyke crystals, a crushed walnut and water mixture that stains the wood and brings out the quarter grain – you might find something similar in old panelled libraries. Once stained, beeswax is rubbed into the oak and then buffed.

‘I have been collecting fittings for some time. I have managed to collect a full set of brass clam lights with switches to suit, the sink is of hammered copper with a brass galley pump. The Blakes Minor heads has a hand-painted ‘bird bath’ basin next to it with a brass soap holder that came from an old ocean liner.

‘In the next few weeks I hope to get some good sailing shots and shall send them over.’

‘Best wishes, Will’

Stirling & Son traditional yacht builders and wooden boat repairers can be contacted via their website or by phone on 01822 614259.

Leave a Reply